Instruction manual
5.3.3 Buttons for setting the end positions
Buttons for setting the end positions inside the actuator
The following table describes the functions of buttons shown above:
Button
Adjustment mode
("SET" button pressed for ~3 s)
SET
Press the button, until the color
of the LED of which the
assigned position is to be
changed lights up (e. g. green –
CLOSE)
STORE
Saving the position moved to
CCW
Moving counterclockwise
CW
Moving clockwise
The following table describes the functions of button combinations:
Button
Function
combination
(press ~3s)
SET + CCW
LED color assignment
SET + CW
Factory reset
Error mode
LED flashes yellow
Acknowledge
the error (instead of
disconnecting
the power supply)
Action
Inverting colors
Actuator will be set to the values pre-set
at the factory; all positions will be
deleted
Design and function
49