GF EA25-250 Bedienungsanleitung

Electric actuators type EA25-250:
Monitoring
Instruction Manual
The technical data are not binding and not expressly
warranted characteristics of the goods. They are
subject to change. Our General Conditions of Sale apply.
Using the monitoring, the instruction manual of the electric
actuator type EA 25-250 must be observed.
Intended use
Accessory board Monitoring
The monitoring can be used with the electric actuators type EA25, EA45, EA120
and EA250, both with the 24V AC/DC as well as the 100-230V AC version. The
board is to be plugged into the housing of the actuator in the provided slots.
Description Code
Monitoring 199 190 602
1 Function
The monitoring enables four functions: Cycle time extension, Cycle time
monitoring, Cycle counter and Motor current monitoring.
Nr. Description
1 Cycle time extension
2 Cycle time monitoring
Cycle counter
3
Monitoring a selected maximum number of cycles
Motor current monitoring
4
Monitoring a selected maximum motor current
2 Assembly of the monitoring board
CAUTION!
Disconnect the actuator from the supply voltage.
1. Remove housing cover of the electric actuator (loosen the 4 screws,
open cover).
Via the BCD switches 1 to 4 the
monitor settings are made. The
different functions work
independently of one another.
700278094
GFDO_6430 / DE EN/ 05 (03.2023)
© Georg Fischer Piping Systems Ltd
CH-8201 Schaffhausen/Switzerland
Georg Fischer Piping Systems Ltd CH-8201 Schaffhausen
Phone +41 (0)52 631 30 26 / info.ps@georgfischer.com / www.gfps.com
2. Take the monitoring board out of the packaging and check for
damages.
CAUTION!
Do not touch the board itself. Electrostatic discharge can damage the
components.
3. Insert board vertical on the backside of the main board onto the red
plug.
CAUTION!
Ensure that the board sits in the lateral guides and snaps.
4. Make desired settings according to 3 "Settings".
5. Stick scheme label into housing cover.
6. Put the cover back in place and tighten the screws with 1 Nm.