STIEBEL ELTRON BHE 50 Plus Bedienung Und Installation Seite 58

Problems
Traces of dirt appear
on the wall around
the device.
The last elements
top and bottom are
cooler than the rest
of the device
The Expert Menu is
not accessible.
The unit does not
follow internal
programming
commands.
An error code is
displayed
The unit does not
follow external
programming
commands.
If you have not been able to solve your problem, contact your distributor/installer with the
reference numbers of the appliance. They are located on the side of the unit
room temperature.
the appliance you purchased.
A Standards, quality marks
B Trademark
C Commercial Code
D Manufacturing reference
E Serial No.
F Manufacturer No.
When functioning, the device will be normally warm; the maxi-
mum surface temperature being limited in accordance with the
your device is still too warm, make sure the power is adapted to
the size of your room (we recommend 100 W/m2 for a ceiling
draught which would disrupt its functioning..
conduction.
transmitted its heat.
You saved a PIN. You must enter your PIN to access the Expert .
If you forgot your PIN, enter the code 081.
Make sure the date and time are set.
Make sure the unit is in PROG mode and internal programming
has been selected.
Err 3: connection sensor fault.
Contact your installer Contact your installer Contact your installer.
inlet or outlet are not obstructed.
Make sure the programming unit is correctly used (see Program-
Verify that the device is in Prog mode inactive.
.
Chek
A
(photo non contractuelle)
58
. Measure the .
B C
6
F E
D