Connecting Via A Wireless Lan; Connecting Via A Usb Cable; Checking Before The Setup; Switching The Connection Method To Wireless Lan - Canon imageRUNNER 2204 series Erste Schritte

Setting Up the LAN Connection
1
Connect the LAN cable.
The IP address will be automatically configured in 2
minutes. If you want to set the IP address manually, see
the following items.
e-Manual "Network" ► "Connecting to a Network" ►
"Setting IP Addresses"
2
Install the drivers on your computer using the User
Software and Manuals CD-ROM/DVD-ROM.
See "For details on the installation procedures:" (P.10).
NOTE
The scanner driver cannot be installed if the
machine and your computer are connected in an
IPv6 environment.
Proceed to "Setting a Paper Size and Type" (P.10).

Connecting via a USB Cable

Connect the USB cable after installing the drivers.
1
Install the drivers on your computer using the User
Software and Manuals CD-ROM/DVD-ROM.
See "For details on the installation procedures:" (P.10).
2
Connect the USB cable.
Proceed to "Setting a Paper Size and Type" (P.10).

Connecting via a Wireless LAN

Checking Before the Setup

Internet
Is the computer connected to the router (access point)
correctly by a LAN cable or wireless LAN?
For more information, see the instruction manual for the
network device you are using, or contact the networking
device manufacturer.
Have the network settings on the computer been
completed?
If the computer is not properly configured, you may not use
the wireless LAN connection even after completing the
following settings.
NOTE
• You cannot connect both the wired LAN and wireless
LAN at the same time. In addition, the machine is set to
the "Wired LAN" by default.
• When you connect to a network environment that is
not security protected, your personal information
could be disclosed to third parties. Please use caution.
• If you connect through a LAN in the office, contact your
network administrator.

Switching the Connection Method to Wireless LAN

1
Tap <Menu> in the Home Screen.
2
Tap <Network Settings>.
If a screen for entering a System Manager ID and PIN is
displayed, enter the System Manager ID and PIN, tap <Apply>,
and press .
3
Tap <Select Wired/Wireless LAN>.
4
Tap <Wireless LAN>.
Select LAN
Wired LAN
Wireless LAN
Wireless LAN Router
En
7