Replacing The Lamp; Closing The Door; Technical Data - Electrolux ERN1300AOW Benutzerinformation

12 www.electrolux.com
Problem
Door does not open easily. You attempted to re-open
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

8.2 Replacing the lamp

The appliance is equipped
with a long-life LED interior
light.
It is strongly recommended
to use original spare parts
only.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
CAUTION!
Disconnect the plug from the
mains socket.
1. Using a screwdriver, remove the
screw from the lamp cover.
2. Detach the lamp cover in the
direction of the arrows.

9. TECHNICAL DATA

9.1 Technical data
Height
Possible cause
the door immediately after
closing.
3. Replace the lamp with the one that
4. Reassemble the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains
7. Open the door.

8.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
3. If necessary, replace the defective
mm
Solution
Wait a few seconds be‐
tween closing and re-open‐
ing of the door.
has identical characteristics and is
specifically designed for household
appliances.
socket.
Make sure that the light switches on.
to assembly instructions.
door gaskets. Contact the Authorised
Service Centre.
815