Periodic Cleaning; Defrosting Of The Refrigerator - Electrolux ERN1300AOW Benutzerinformation

7.3 Periodic cleaning

CAUTION!
Do not pull, move or damage
any pipes and/or cables
inside the appliance.
CAUTION!
Do not damage the cooling
system.
The equipment has to be cleaned
regularly:
1. Clean the inside and accessories
with lukewarm water and some
neutral soap.
2. Regularly check the door seals and
wipe them clean to ensure they are
clean and free from debris.
3. Rinse and dry thoroughly.
4. If accessible, clean the condenser
and the compressor at the back of
the appliance with a brush.
This will improve the performance of
the appliance and save electricity
consumption.
7.4 Cleaning the air channels
1. Remove the plinth (A), then the
ventilation grid (B).
2. Clean the ventilation grid. (Refer to
"Cleaning the ventilation filter ". )
3. Carefully pull the air deflector out (C),
checking that there is no water left
from the defrosting.
4. Clean the lower part of the appliance
with a vacuum cleaner.
C B A
7.5 Cleaning the ventilation
filter
The filter can be removed for washing.
The appliance is equipped with an air
inlet filter (1) and an air outlet duct (2) on
the ventilation grid.
1. Pinch flaps (A) and (B) with fingers.
2. Pull the filter down.
3. Pull the filter out.
4. To replace the filter reverse the
process.
7.6 Defrosting of the
refrigerator
Frost is automatically eliminated from the
evaporator of the refrigerator
compartment every time the motor
compressor stops, during normal use.
The defrost water drains out through a
trough into a special container at the
back of the appliance, over the motor
compressor, where it evaporates.
It is important to periodically clean the
defrost water drain hole (F) situated
under the salad drawers to prevent the
water overflowing and dripping onto the
food inside. Use the special cleaner
provided (P), which you will find already
inserted into the drain hole.
ENGLISH 9
2
A B
1