3M SCPFWMSV2 Installationsanleitung Seite 7

3M ™ Folding Wall Mount SCPFWMSV2
6.2 Install the long mounting lag bolts through the
leveling screws and tighten securely.
6.3 Skip to Step 9.
7.0 3M ™ Wall Mount Bracket Installation
(For Use With Concrete Block or Stud Walls)
7.1 Determine desired size and location of projected
image and mark the location of the top and center of
the image.
7.2 Align template with mounting holes in bracket and
secure to bracket with tape.
7.3 Locate the "top of image" line of the template for
the desired image size and then align "top of image"
and "image center line" lines with the location of the
desired image size. Mark positions for four mounting
holes according to the next step.
3M ™ Folding
Wall Mount
Mounting Template
Descripteur de Support
Montage-Schablone
Modelo Del Montaje
Mascherina Del Montaggio
架置模板
土台のテンプレート
For use with:
Pour l'usage avec
Für Gebrauch mit:
Para el uso con:
Per uso con:
至于使用与:
사용를 위해에:
使用のため下記のものの:
SCP715, SCP717,
SCP740
SCP715, SCP717
SCP740
© 2009 3M. All Rights Reserved.
7.4
To reduce the risk associated with impact:
When installing the wall mount bracket, use only the 1½" (38 mm)
long lag anchors included with the bracket, not the 1" (25 mm)
short lag anchors.
Align with holes
in bracket
Image Area
7
Concrete block walls:
Mark the hole positions in the vertical joints between
the concrete blocks and then using a 1/2" (13 mm)
bit, drill 4 holes 1-5/8" (41 mm) deep into the vertical
joints between the concrete blocks. Install 4 long
anchors in the holes.
CAUTION
1 6 i n
m m )
( 4 0 6
4X
LONG
Stud walls:
Mark the holes at the center of the studs and then
using a 3/16" (5 mm) bit, drill 4 holes 1-1/2" (38 mm)
deep through the wall into the studs.
4X
1/2–5/8"
(13–16 mm)