3M SCPFWMSV2 Installationsanleitung Seite 6

4.2 Align the cables alongside the power cable and
secure using cable ties.
5.0 Solid Wall Installation
(For Concrete Block or Stud Walls, Skip to Step 7)
5.1 Determine desired size and location of projected
image and mark the location of the top and center of
the image.
5.2 Locate the "top of image" line of the template for
the desired image size and then align "top of image"
and "image center line" lines with the location of the
desired image size. Then mark the positions of the
template's four cross-hairs on the wall.
3M ™ Folding
Wall Mount
Mounting Template
Descripteur de Support
Montage-Schablone
Modelo Del Montaje
Mascherina Del Montaggio
架置模板
土台のテンプレート
For use with:
Pour l'usage avec
Für Gebrauch mit:
Para el uso con:
Per uso con:
至于使用与:
사용를 위해에:
使用のため下記のものの:
SCP715, SCP717,
SCP740
SCP715, SCP717
SCP740
5.3
Note: Use a 1/2" masonry drill bit for solid concrete
5.4
6.0 Attach to Wall
6.1
Image Area
6
3M ™ Folding Wall Mount SCPFWMSV2
Using the appropriate bit, drill 4 holes for the
mounting lag bolt anchors. Install the short anchors
in the upper holes, and the long anchors in the
lower holes.
walls or a 3/16" drill bit for wood walls. Do not use
anchors for wood walls, only use screws.
Using a 3/8" socket, install the 2 short (upper)
mounting lag bolts, leaving 1/2" (13 mm) of the
screw protruding from the wall. DO NOT INSTALL
THE LONG (LOWER) LAG BOLTS.
1/2"
(13 mm)
Hang the wall mount base on the mounting lag bolts.
Using a 3/8" socket, tighten the mounting lag bolts
securely.
© 2009 3M. All Rights Reserved.