Cleaning And Storage; Low Battery Indication - Xavax 00104983 Bedienungsanleitung

FAULT MESSAGE DISPLAY
UnSt: Unstable
The scale is unstable and the unit will turn off automatically. Place the cup on a flat
table and turn on the unit again by pressing [0] button once.
Err: Error
The scale is overloaded. The weight or volume in the cup exceeds the maximum
display range (refer "Specification" section)
CALIBRATION
To ensure accurate measurement, you are suggested to check the weight of an empty cup every
time you first turn on the unit. It should read 0 gram (or oz) for your empty cup.
Calibration for the cup is needed ONLY when the reading of your EMPTY cup is higher than zero
(gram, oz, cups, fl oz or ml). The calibration process will reset the reading to zero for the empty
cup.
To calibrate,
1) Make sure the transparent cup is attached to the base.
2) Make sure the cup is empty. Clean the unit with a dry cloth to remove any excess liquid
on the cup.
3) Turn on the unit by a single press of the [0] button.
4) Make sure the cup is placed steadily on a flat surface. Hold [0] for 6 seconds until "CAL"
flashes. Do not touch or move the cup when "CAL" is flashing. The display reading will show
"0" and the calibration is completed

CLEANING AND STORAGE

- The transparent cup is suitable for dishwashers and it is detachable for cleaning.
Press the button below the handle to unlock and detach the cup from the base
- Only clean the transparent cup with cold or warm water together with optional mild cleaning
detergent. Do not use boiling water to clean the transparent cup as it can withstand up to 70C
maximum.
- Detach the transparent cup and use damp cloth to clean the base and the handle.
- Never immerse the base & handle in water or put into dish washing machine for cleaning
Storage
- To extend product life span, remove any food or liquid from the cup scale when it is not in use
so that it is not loaded with weight
- After cleaning, place the cup scale in a location with good air ventilation

LOW BATTERY INDICATION

Low battery indication is available. Replace the batteries and follow the setup procedure in this
instruction manual.
10