Electrical Diagram - Centrostyle 5111 Gebrauchs- Und Wartungshandbuch

WARNING! Disconnect the edger from the mains before opening it. Take great
care when working inside the edger or when fitting spares. Risk of cutting or
pinching! The simple design of the edger allows quick and easy access to the
diamond wheel drive belt and sponges.
• Remove the two cross-head screws underneath the water drip tank securing the
top cover and remove the top cover. To change the drive belt, simply pull it off its
pulleys. No tools are required. Position the new belt on one pulley first and then
pull it over the other pulley.
• Simply pull out and replace the sponges by hand. Lift off the spray shield to
access the bottom sponge ´.
• If the repairs described above do not solve the problem, do not attempt any
other work yourself but contact your nearest Service Centre.
• Never attempt to repair electrical or mechanical parts yourself. Never refer re-
pairs to unauthorised personnel.
• To ensure constant efficiency and operational safety, use only original spare
parts. Spares can be ordered from Centro Style S.p.A.
• Centro Style S.p.A. declines all responsibility for injury to persons or damage to
property resulting from repair operations other than those described in this
manual or from the use of non-original spare parts.

Electrical diagram

M Motor
C Motor capacitor
S1 Main power (motor) switch
S2 Direction change switch
GB
9