Optional Equipment; Changing The Baffle Plate; Changing The Burn Plates - Jøtul F 600 Handbuch

ENGLISH
4.0 Service
Warning! Any unauthorised change to the product is illegal.
Only use original spare parts.

4.1 Changing the baffle plate

1. The baffle plate consists of 2 cast iron plates and rests on top
of the pipes that supply secondary air.
2. To remove, lift a little upwards in the middle and take them
out.
3. To install, replace both plates in the same manner. Make sure
they are fitted closely against the back wall.
4. Then place the insulating blanket on top of the baffle
plates.

4.2 Changing the burn plates

1. The stove has burn plates on the sides and in the back. The
burn plate on the right door is fastened with a screw.
2. To remove, unfasten the screw and remove the burn plates.
3. To install, follow the same procedure.
10

5.0 Optional equipment

5.1 Connecting pipe for outdoor
ventilation - Cat. No. 221032
With the aid of a connecting pipe for outdoor ventilation and a
flexible tube, combustion air can be connected to the product
directly from the outside. In this manner, the fireplace will always
be supplied with the air needed to achieve proper combustion.
Fresh air supply direct from the exterior or from the chimney
with air vents
1. Insert the connecting pipe into the air inlet under the
product.
2. Unfold the pipe's 3 flaps (fig. 4A) inside the air inlet.
3. Attach a flexible tube (Ø 100 mm) directly to the fireplace's
connecting pipe by using a hose clamp and attach it to the
wall outlet/chimney.
5.2 Rear heat shield cat.no.
Assembly instruction follows the product.
154329