Tylo Prime+ 1814 Bedienungsanleitung Seite 4

Floor panel ( 1): Put the floor panel on a level surface 8-16 cm from the wall panel and no more
Box
than 152 cm away from a 230V socket.
Position the floor panel in such a way that the slot for the glass section is at the front of the sauna.
Note: Put the ceiling, bench valance and bench aside until the corresponding steps.
Rear wall panel (2 sections):
• Place the left back wall panel section into the left hand slot.
• Place the right back wall panel section into the right hand slot.
• Lift both back wall panel sections at the same time.
Note – Put the front wall panel aside until the "Front wall panel" section.
Page 4