air&me LARY Bedienungsanleitung Seite 13

FAQ
Circumstance
The product
does not work
Drop in the
appliance
performance
(less water in
the tank)
Abnormal noise
E2 display
LO display
HI display
CL display
CH display
Reason
> The product is not correctly
plug or there is an electrical
problem.
> There is a problem on the
electrical system of your
house.
> The tank is full.
> The tank is not properly
placed.
> The pre-filter is dirty what
obstructs the air flow.
> The air inlet or outlet is
obstructed by something.
> Temperature is too low.
> Humidity rate is already low.
> Something obstructs the fan.
> The product has a
functioning problem.
> Hygrometry sensor problem.
> The ambient humidity is less
than 35%. The device stops
for safety.
> The ambient humidity level
is greater than 95%. The
device stops for safety.
> The ambient temperature is
below 5°C. The device stops
for safety.
> The ambient temperature
is above 35°C. The device
stops for safety.
Solution
> Plug the socket correctly and
check the voltage and the good
functioning of your electrical
system. Avoid multi sockets.
> Empty the tank.
> Push and place the tank properly.
> Clean the pre-filter.
> Leave at least 20cm behind,
around and in front of the
appliance.
> Below 15°C the product works in
Defrost Mode. It cannot therefore
dehumidify to a maximum of its
capacity.
> Make sure that no object obstructs
the air flow.
> Contact your reseller for service
support.
> Contact your reseller for service
support.
> Increase the room humidity rate
with an air humidifier (www.
airandme.fr/en/air-humidifier).
> Increase the room temperature
with a space heater (www.
airandme.fr/en/fan-heater-air).
13