Repair And Spare Parts; Disassembly; General Information; Removing Acoustic Tiles Cleanly - Sigel Sound Balance Montageanleitung Und Gebrauchsanweisung

5.2

Repair and spare parts

New tesa adhesive strips are available to purchase from SIGEL if you wish to mount the acoustic
®
tiles in a different place.
A set of 4 spare adhesive strips is available, product code SB190.
To affix new adhesive strips to the acoustic tiles, please also refer to section 6.3 "Affixing new
adhesive strips."
6

Disassembly

6.1

General information

Thanks to the tesa
You can then replace the tesa
6.2

Removing acoustic tiles cleanly

Warning
`
`
The acoustic tiles are removed cleanly as follows:
1. Clean the worst of the dust and dirt from the acoustic tiles.
2. Use a tool with a wide, sharp blade.
We recommend a standard utility knife or wallpaper scraper.
Always take care when using tools.
3. Carefully slide the blade behind one of the 4 corners of the tile.
Be careful not to damage the surface of the wall.
4. Pierce the foamy part of the adhesive strip, splitting it apart.
5. Repeat until the corner easily pulls away from the wall.
6. Carefully but firmly, pull the tile, gradually lifting all other corners away from the wall.
Do not bend the tile while pulling it away.
7. If the tile does not pull away from the wall, split the adhesive strip on the other corners with
a tool as described in steps 3-5.
8. The remains of the adhesive strip can simply be peeled from the wall. Slowly peel the inte-
grated reinforcement film with the residue adhesive away from the surface at an angle of
between 90° and 135°.
The acoustic tiles have now been removed cleanly.
9
6.3

Affixing new adhesive strips

It is simple to remove the acoustic tiles and mount them in a different place using new tesa
sive strips from the SIGEL range.
Warning
`
`
New tesa adhesive strips are attached to the acoustic tiles as follows:
®
1. Place the tile on a soft surface to avoid scratches or other damage.
2. Clean off the remains of the previous strips with a standard wallpaper scraper and house-
hold cleaner to remove any residue adhesive.
3. The aluminium surface needs to be smooth, clean and free of residue before you attach the
new tesa
4. Clean the aluminium surface with the enclosed tesa
Wipe the cloth across the surface several times in the same direction.
Allow the surface to dry completely before attaching new strips.
5. Peel the tesa
on the aluminium surface.If the tile is not being mounted onto a transparent surface, you
can place the new adhesive strips in the middle of the frame. In this case, it is not necessary
to remove the residue from the previous strips.
20
adhesive strips, the acoustic tiles are easy to remove without leaving residue.
®
adhesive strips and mount the acoustic tiles in a different place.
®
Be careful when using sharp objects or tools to avoid damaging the acoustic tiles
or the surface of the wall.
Wear gloves to avoid cuts.
Do not expose the adhesive tape to extreme temperatures (not < 10°C or > 40°C)
just before use.
Ensure that the conditions are ideal before affixing the strips. The adhesive tape
should be affixed at room temperature (15-35°C) and at a humidity of 50-70%.
adhesive strips.
®
adhesive strips off the backing film and place them in the required position
®
cleaning cloth.
®
Sound Balance acoustic tiles
adhe-
®