Installation; Safety; General Safety Instructions; Instructions, Standards And Regulations - STIEBEL ELTRON ESH 10 U-N Trend Bedienung Und Installation

INSTALLATION

Safety

INSTALLATION
6. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
6.1

General safety instructions

We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
6.2

Instructions, standards and regulations

Note
Observe all applicable national and regional regulations
and instructions.
7.

Appliance description

The appliance is intended to heat cold water for supplying a single
draw-off point.
ESH 10 U-N Trend
The open vented (non-pressurised) appliance is only suitable for
undersink installation.
ESH 10 O-N Trend
The open vented (non-pressurised) appliance is suitable only for
oversink installation.
7.1

Standard delivery

The following are delivered with the appliance:
- Wall mounting bracket
- Installation template
7.2

Accessories

The following taps are available as accessories for open vented
operation:
Mixer taps
- WST, WUT
Mono-lever mixer taps
- MEW, MES, MEWC
Sensor tap
- WEN
www.stiebel-eltron.com
8.

Preparation

f Flush the water line thoroughly. f
Water installation
No safety valve is required.
Taps
Sealed unvented taps are not permitted.
f Install a tap for open vented operation. f
8.1

Installation site

Material losses
!
Install the appliance in a room free from the risk of frost.
Material losses
!
Mount the appliance on the wall. The wall must have
sufficient load bearing capacity.
Note
Ensure that the appliance is freely accessible for main-
tenance work.
Always install the appliance vertically and near the draw-off point.
8.1.1 ESH 10 U-N Trend - undersink installation
Note
The ESH 10 U-N Trend is designed exclusively for under-
sink installation. The water connections of the appliance
are at the top.
ESH 10 U-N Trend | ESH 10 O-N Trend | 15