Battery Removal; Product Specification - Zoef Robot SR806W SJAAN Bedienungsanleitung

L0X1 Left wheel overloaded
L0X2 Right wheel overloaded
L0X3 Left and right wheels overloaded
L0X4 Left side brush overloaded
L0X5 Left wheel and left side brush overloaded
L0X6 Right wheel and left side brush overloaded
L0X7 Left and right wheels, left side brush overloaded
L0X8 Right side brush overloaded
L0X9 Left wheel and right side brush overloaded
L0XA Right wheel and right side brush overloaded
L0XB Left and right wheels, right side brush overloaded
L0XC Left and right side brushes overloaded
L0XD Left wheel, left and right side brushes overloaded
L0XE Right wheel, left and right side brushes overloaded
Left and right wheels, left and right side brushes
L0XF
overloaded
L02X Roller brush overloaded
Note:
1. There is no problem for the robot when it displays L000
2. X is the number or letter might appear on display for different fault
3. If robot displays E001 or E004, please directly find the relative solution referred in troubleshooting
4. If robot displays EC07, please find ECXX and EXXX for relative solution referred in troubleshooting.
5. Like wise, if robot displays EE91, please find EXX1, EEXX and EX9X for relative solution referred in
troubleshooting.
6. If above solution does not work, please try below:
a. Reset the robot by switching off the unit and then turn it on, and check again.
b. If it still does not work after reset, contact the after sales.
7. UV light might hurt your eyes, so please do not stare directly at the light when turned on.

Battery Removal

1. Remove the screws on battery cover with a screw driver.
2. Remove the battery cover.
3. Grasp the insulating tape at two sides of the battery and lift the battery.
4. Unplug the wire connector that links the battery and robot.
Note: Only use the original battery of the product, otherwise it may cause product damage.
Product specifications
Check if it's stuck or wired by obstacles
16