Starting Up/Standby/Sleeping/Power Off - Zoef Robot SR806W SJAAN Bedienungsanleitung

b. Press"
station for recharging as shown in Fig.b.
Note:
a. When robot is charging, LED panel will gradually show "11:11", from left to right.
b. Once charging is completed, LED panel will show "11:11".
c. In the standby status, the robot will broadcast voice "please charge" when battery power is low.
d. In the working status, the robot will return to charging station automatically when battery power
is low.
To ensure optimum battery performance:
a. Before first use, charge the robot for 12 hours.
b. Charge the robot as soon as battery power is low.
c. The robot will return to charging station automatically when it has finished cleaning or if battery
power is low.
d. If the robot is not to be used for a long time, fully charge the battery, turn the power switch off,
remove and store it in a cool, dry place.
e. If the robot is not to be used for more than 3 months, charge the robot for 12 hours, turn the
power switch off, remove and store it in a cool, dry place.
Product Operation
2. Starting up/ Standby/ Sleeping/ Power off
A. Starting up
a. Press the "ON/OFF" switch on the side of the robot to "ON".
b. Press
Note: If robot is in sleeping mode, press
wake up the robot from sleeping mode, then press
automatically.
B. Standby
Standby means the robot's main power is "ON", and the robot is ready to use. It can be changed
to standby mode by below methods:
a. During robot cleaning, press
b. During robot cleaning, press ON/OFF button on remote control to power off the robot.
C. Sleeping
In sleeping mode, the robot can only be waken up from
on remote control in order to save power. To turn robot into sleeping mode from standby mode:
a. Keep pressing
b. Robot will automatically enter sleeping mode if there is no command received for more than
60 seconds.
" on robot or "HOME" on remote control to operate the robot to go charging
on main body or ON/OFF on remote control to start cleaning.
on main body for 3 seconds.
on main body or ON/OFF on remote control to
on main body to enter standby mode.
8
again, the robot will start cleaning
button on main body or ON/OFF