Menu Level 3: Operating Mode - Dometic RT780 Montageanleitung

CoolAir RT780
8.4

Menu level 3: Operating mode

The unit always starts with a defined operating mode for room temperature. This
parameter can be configured:
➤ Start configuration mode (chapter "Starting and ending configuration mode"
on page 21).
✓ The first digit of the display shows the menu level and the second and third
show the parameter which can be set.
➤ Press the + button twice to switch to menu level 3.
➤ Press the
✓ The digits in the display flash until the parameter you entered is confirmed.
➤ Use the + and – buttons to set the mode with which the unit starts up:
Characteristic
figure
0
1
2
3
➤ Press the
✓ The set value is saved and is then used when the unit is restarted.
✓ You are now in menu level 3 again and can use the + and – buttons to switch
between menu levels.
EN
button to change the parameters.
Operating mode
Automatic mode
Operating mode 1
Operating mode 2
Operating mode 3
button to confirm your entry.
Configuration of unit software
23