Operating Determinations - EuroLite LED PAR ty Hybrid Spot Bedienungsanleitung

running, the device must be checked by a specialist if the liquid has reduced any insulation. Reduced
insulation can cause mortal electrical shock.
There must never be any objects entering into the device. This is especially valid for metal parts. If any metal
parts like staples or coarse metal chips enter into the device, the device must be taken out of operation and
disconnected immediately. Malfunction or short-circuits caused by metal parts may cause mortal injuries.
Never look directly into the light source, as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!
Please consider that damages caused by manual modifications to the device are not subject to warranty.
Keep away children and amateurs!

OPERATING DETERMINATIONS

This device is a fixed general purpose luminaire. This product is allowed to be operated with an alternating
voltage of 100-240 V, 50/60 Hz and was designed for indoor use only.
This device is designed for private use and not suitable for professional use.
This product is not a toy. Keep it out of the reach of children and pets. Do not leave packaging material lying
around carelessly.
Lighting effects are not designed for permanent operation. Consistent operation breaks will ensure that the
device will serve you for a long time without defects.
Handle the product with care. It can be damaged by impacts, blows, or accidental falls, even from a low
height.
Make sure that the installation complies with the standards and rules that apply in your country. The device
must be installed securely and prevented from falling down.
When choosing the installation spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
This device must never be operated or stockpiled in surroundings where splash water, rain, moisture or fog
may harm the device. Moisture or very high humidity can reduce the insulation and lead to mortal electrical
shocks. When using smoke machines, make sure that the device is never exposed to the direct smoke jet
and is installed in a distance of 0.5 meters between smoke machine and device. The room must only be
saturated with an amount of smoke that the visibility will always be more than 10 meters.
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters. The relative humidity must not exceed 50 % with an ambient temperature
of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.
The symbol determines the minimum distance from lighted objects. The minimum distance between
- - -m
light-output and the illuminated surface must be more than this value.
This device is only allowed for an installation via the mounting bracket. In order to safeguard sufficient
ventilation, leave 50 cm of free space around the device.
The housing must never touch surrounding surfaces or objects.
Make sure that the area below the installation place is blocked when rigging, derigging or servicing the
fixture.
The maximum ambient temperature T a = 45° C must never be exceeded.
Operate the device only after having become familiarized with its functions. Do not permit operation by
persons not qualified for operating the device. Most damages are the result of unprofessional operation!
HEALTH HAZARD!
13/20 00119979, Version 1.1