Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Contents
Safety
Safety
Click on any of the subjects in the contents list to jump
straight to that section.
SDC965B DL400 Operator Guide
Safety
Safety
Follow the normal safety precautions for all office equipment:
•
Use only Pitney Bowes approved supplies, in particular aerosol dusters. Improper
storage and use of aerosol dusters or flammable aerosol dusters can cause an
explosive-like condition that could result in personal injury and/or property damage.
Never use aerosol dusters labelled flammable and always read instructions and safety
precautions on the duster label.
•
To obtain supplies, please contact our Supply Line
Data Sheets can be obtained on the web or from our Supply Line
Contact Information List for more information.
•
Use the power cord supplied with the machine and plug it into a properly grounded
wall outlet that is located near the machine and is easily accessible. Failure to properly
ground the machine can result in severe personal injury and/or fire.
•
Avoid touching moving parts or materials while the machine is in use. Keep hands,
loose clothing, jewellery and long hair away from all moving parts.
•
Do not remove covers or defeat safety interlock switches. Covers enclose hazardous
parts that should only be accessed by properly trained service personnel. Immediately
report to service any damaged or non-functioning components that renders the unit
unsafe.
•
Place the unit in an accessible location to allow for proper venting of the equipment and
to facilitate servicing.
•
The power cord wall plug is the primary means of disconnecting the machine from the
AC supply.
•
Do not use an adapter plug on the line cord or wall outlet.
•
Do not remove the ground pin from the line cord.
•
Avoid using wall outlets that are controlled by wall switches, or shared with other
equipment.
•
Do not route the power cord over sharp edges or trap between furniture.
•
Ensure there is no strain on the power cord and that it does not become jammed
between the equipment, walls or furniture.
•
Be certain the area in front of the wall receptacle into which the machine is plugged is
free from obstruction.
•
Before clearing a stoppage, be sure machine mechanisms come to a stop.
•
When removing stalled material, avoid using too much force to protect against minor
personal injury and damaging equipment.
•
To prevent overheating, do not cover any vent openings.
•
Operation of this equipment without periodic maintenance will inhibit optimum operating
performance and could cause the equipment to malfunction. Contact your machine
supplier for required service schedule.
•
Read all instructions before attempting to operate the equipment.
•
Use this equipment only for its intended purpose.
•
Always follow the specific occupational safety and health standards for your workplace.
EN
to place orders. Material Safety
TM
. Refer to the
TM
<< Return to Contents
Werbung
Kapitel
Inhaltsverzeichnis
