Adjusting The Contrast And Brightness; Remotely Controlling The Printer - Sony UP-895 Gebrauchsanweisung

Printing
Adjusting the Contrast and
Brightness
You can adjust the contrast and brightness of the
printout.
CONTR
Note
To adjust the contrast and brightness while confirming
the adjusted image on the video monitor, set DIP Switch
8 (OUTPUT) to EE (SW-UP).
After adjusting the contrast and brightness, be sure to
reset DIP Switch 8 to THRU (SW-DOWN).
Since the video signal is directly input to the video
monitor without being processed by the printer when the
setting is THRU, you can monitor the video signal as it
is input directly from the video equipment.
To adjust the contrast
You can adjust the contrast of image using the CONTR
control.
To make the contrast stronger, turn the CONTR
control clockwise.
To make the contrast weaker, turn the CONTR control
counterclockwise.
30
Operation
BRIGHT
To adjust the brightness
You can adjust the brightness of printouts using the
BRIGHT control.
To make the image brighter, turn the BRIGHT control
clockwise.
To make the image darker, turn the BRIGHT control
counterclockwise.
Note
You cannot adjust the image once it has been captured in
memory. Restore an image after adjustment by pressing
the PRINT button.

Remotely Controlling the Printer

You can remotely control the printer using the RM-91
remote control unit or the foot switch connected to the
REMOTE connector on the rear panel.
Since the button on the remote control unit or foot
switch functions exactly same as the PRINT button,
pressing either of them during printing or copying results
in an image being captured and immediately printed
when DIP Switch 1 (INTERRUPT) on the rear panel is
set to ON (SW-DOWN). (See page 24.)