Operation; Menu Structure - EuroLite MULTIFLOOD PRO IP SMD RGBW STROBE/WASH Bedienungsanleitung

OPERATION

After connecting the device to the mains it is ready for operation. After switching on, the fans run at full
power for a short time. This is an intended cleaning
The display indicates the last operating mode. The operating modes can be selected by means of the display
and the control buttons. All settings remain stored even if the device is disconnected from the mains. The
device can be operated in stand-alone mode via the control board or in DMX-controlled mode via any
commercial DMX controller.

Menu structure

Address
Channel
DMX Monitor
Auto
Speed
Color
Effect on Auto
Mas Mode
Manual
Back L
(Display shutoff time)
Temp
Info
Dimmer curve
Fade time
function.
Display
001-512
4, 5, 7, 13, 15, 31
CH:31
CH:15
CH:13
CH:07
CH:05
CH:04
Auto 00 ~ Auto 36
000 - 255
0 - 17
Dimmer 000 - 255
Strobe 000 - 255
Yes
Master - Slave
No
Dimmer 000 - 255
Strobe 000 - 255
Red 000 - 255
Green 000 - 255
Blue 000 - 255
White 000 - 255
On
60s
120s
300s
Temp 1 XXC°
Temp 2 XXC°
Test 1
Test 2
Reset Yes / No
Version
Curve 0 Linear
Curve 1 Square
Curve 2 InvSquare
Curve 3 S-curve
Speed 0 ~ Speed 7
26/36
DMX address setting
Setting DMX channel mode
Manual setting of DMX values for each DMX Channel
Program 00 ~Program 36
(00 = continuously on)
Program running speed
slow > fast
Setting the color/color effects of the
Auto program
Brightness dark > bright
Strobe-Effect slow > fast
Master/Slave Function on
Master/Slave Function off
Brightness dark > bright
Strobe-Effect slow > fast
Intensity 0 – 100 %
Intensity 0 – 100 %
Intensity 0 – 100 %
Intensity 0 – 100 %
Constantly on
Off after 60 seconds
Off after 120 seconds
Off after 300 seconds
Temperature of the LCD panel
Inside temperature
Restore factory settings
Current software version
Dimmer curves
Fade fast > slow
Function
00121741.DOCX, Version 1.0