Stand-Alone Mode - EuroLite MULTIFLOOD PRO IP SMD RGBW STROBE/WASH Bedienungsanleitung

Attention! In stand-alone mode, the full light output of the device cannot be called up.

Stand-alone mode

DMX Monitor
Here you can set the DMX values for each channel in the desired DMX channel mode manually.
1 Press the MODE button so many times until DMX Monitor is indicated on the display. Confirm with the
ENTER button.
2 Use the buttons UP and DOWN to select the desired DMX channel mode and confirm with the ENTER
button.
3 You can now set the desired DMX value for each channel in the chosen DMX mode. Confirm with the
ENTER button.
Automatic mode
In automatic mode, various show programs are available that run at an adjustable speed. Additionally, a
desired color can be set.
1 Press the MODE button so many times until Auto is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to select the desired show program. Confirm with the ENTER
button. (Program 00 is a single color steady on).
2 The display now indicates Speed. Confirm with the ENTER button. Use the buttons UP and DOWN to
adjust the running speed of the program from 000 (slow) to 255 (fast). Confirm with the ENTER button.
3 Now the display now indicates Color. Confirm with the ENTER button. Use the buttons UP and DOWN
to set the desired program color from 0 to 18. Confirm with the ENTER button.
With the MODE button you can return to the main menu.
Effect on Auto
In this mode, you can set the desired brightness and strobe speed of the programs in Automatic Mode.
1 Press the MODE button so many times until Effect on Auto is indicated in the display. Confirm with the
ENTER button.
2 The display shows Dimmer. Confirm with the ENTER button
3 Use the buttons UP and DOWN to select the desired brightness, from 000 (dark) to 255 (bright).
Confirm with the ENTER button.
4 The display now indicates Strobe. Confirm with the ENTER button.
5 Use the buttons UP and DOWN to adjust the strobe speed from 000 (slow) to 255 (fast). Confirm with
the ENTER button.
With the MODE button you can return to the main menu.
Mas Mode
In this mode, you can set the Master and Slave devices.
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
Configure all slave units before connecting the master unit.
1 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
2 Press the MODE button so many times until Mas Mode is indicated in the display. Confirm with the
ENTER button.
27/36 00121741.DOCX, Version 1.0