Dmx Operation - EuroLite MULTIFLOOD PRO IP SMD RGBW STROBE/WASH Bedienungsanleitung

DMX operation

Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 31 control channels.
However, it can also be switched to a mode with 4, 5, 7, 13, or 15 channels if different functions are required.
To be able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller's documentation.
1 Press the MODE button so many times until Address is indicated on the display. Confirm with the
ENTER button.
2 Set the address via the UP and DOWN buttons and press the MODE button to return to the main menu.
3 Now press the MODE button so many times until Channel is indicated on the display.
4 The display indicates 4 CH (4 DMX channels), 5 CH (5 DMX channels), 7 CH (7 DMX channels), 13 CH
(13 DMX channels), 15 CH (15 DMX channels) or 31 CH (31 DMX channels). Use the buttons UP and
DOWN to select the desired number of DMX channels. Confirm with the ENTER button.
4 If no control signals are available, a * will blink on the display. The * will not blink when DMX signals are
being received
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.
The LEDs of the device are divided into different segment groups with 6 segments each, which can be
individually controlled with the following DMX protocol.
6
1
5
4
3
2
30/36 00121741.DOCX, Version 1.0