Klarstein 10029345 Bedienungsanleitung Seite 6

4. Connect the internal lead to the
fan body by clipping together
the two plastic male / female
connectors are firmly clicked
together.
7. Fasten the blade assembly
to the motor with the screws
and spring washers already
attached to the motor.
10. Install the light bulb. (E14
Max 42W, not supplied)
5. Connect the wires from the
earthed mains supply to the
terminal block.
8. Connect the light kit by clip-
ping together the two plastic
male/female connectors.
11. Install the lampshade onto the
lamp gallery by rotating the
lampshade clockwise
6. Lift up the canopy into place
over the mounting plate. En-
sure that you do not trap any
wires.
9. Fit the light kit to the switch
housing by using the three
light kit-fixing screws and star
washers. Ensure that you do
not trap any wires.
6