Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Removing the Diaphragm and
Cleaning
t.
h e Chestpiece:
With the diaphragm side
up, push
the rim at the apex with both
thumbs and roll the rim off
the
edge of the
chestpiece.
Remove
the
diaphragm from the rim and
clean parts in soapy water or
wipe with alcohol. Wipe
chestpiece surfaces with alcohol
or soapy water.
Dry
all parts
and surfaces
thoroughly
before
reassembling.
Assembly and Replacement of
·
the Tunable Diaphragm:
Using your
fingertip,
apply a small
amount of
talcum
powder to the
inside surface of the flexible edge
of
the
diaphragm then align the
rim and diaphragm as a unit. This
will facilitate assembly and
maintain
smooth and quiet
low/
high
frequency
alternation_.
Snap
the diaphragm
with your fingers
to
remove excess talcum
powder.
Insert
the flexible edge of the
diaphragm
into the groove of
the
rim. This
is best accomplished
by
starting with the rim positioned
above the
legible side of the
diaphragm.
Visually exami~e the
ring to
ensure that the flexible
edge
is smoothly engaged inside
the
rim.
Refer to
illustration for
correct
assembly of the non-chill
rim
and
diaphragm.
If
necessary,
flex the
assembly by pinching the
outer rim
edge between the
3
thumb and
fingers. To
attach
the
rim/diaphragm assembly
to the
chestpiece,
engage
the
groove
of
the rim
(with
the diaphragm
attached) around the
chestpiece
at one point and hold
it in
place
with your thumbs. Slowly roll
the
rim around and over the
chestpiece edge using both
thumbs, moving
in
opposite
directions around the
chestpiece.
Visually inspect the edge where
the diaphragm engages the
rim
for uniform containment. Minor
adjustments may
be
made by
slightly pulling and rolling the
rim
away from the diaphragm,
allowing the diaphragm to
slip
into
position.
Werbung
Inhaltsverzeichnis
