Safety Instructions; Description Of Individual Components - VOLTCRAFT MS-18/2 Bedienungsanleitung

6. Safety instructions

In the case of any damages which are caused due to failure to observe these operating instructions,
the guarantee will expire. We do not assume liability for resulting damages.
An exclamation mark inside a triangle points to important notes in the operating manual. Please
read through the entire manual before putting the device into operation.
• The unauthorised conversion and/or modification of the MS18-2 is not permitted because of safety and
approval reasons.
• Never exceed the maximum input quantities.
• A reliable display is only ensured at a temperature range of –10 °C to +50 °C and a frequency range of
50 Hz to 500 Hz. The tester is only authorized for the use in closed and dry rooms.
• Avoid all contact to dampness
• Never use the tester if there are any visible damages. Before each use the device needs to be checked
if it works correctly.
• In commercial and industrial facilities the regulations for the prevention of accidents of laid down by the
professional trade association for electrical equipment and devices need to be observed.
• Static electricity e.g., caused by strong rubbing on the plastic housing, can falsify the reading.
• This tester should be kept out of reach of children.
• The multitester is not suitable to be used as a screwdriver. Be especially careful with voltages larger
than 25 V AC or 35 V DC. With voltages like this you can already suffer a life-threatening electric shock.
• This tester can only be used in electrical circuits which are protected with 10A (and/or no capacities
larger than 4000VA appear). In the case of any queries which could not be answered by these operating
instructions, please a consult specialist or contact our customer service by phone.

7. Description of individual components

1 Measuring tip
2 LED display
3 Battery compartment lid
14