Changing The Volume Level (Level); Setting The Cross-Over Frequency (Crossover Frequency) - Dynaudio SUB 300 Bedienungsanleitung

Operation
LEVEL POWER
SUBWOOFER CONTROL
CROSSOVER FREQUENCY Hz
60 80 100
o
OFF
0
EXT
ON
270
A B C
PRESET
D NAUDIO
A U T H E N T I C F I D E L I T Y
LEVEL POWER
SUBWOOFER CONTROL
CROSSOVER FREQUENCY Hz
60 100
80
o
OFF 0
EXT
o
ON
270
A B C
PRESET
D NAUDIO
A U T H E N T I C F I D E L I T Y
12

Changing the volume level (LEVEL)

The right volume level is one of the critical aspects of correct and seamless integration
of any subwoofer as part of a speaker system. Please also refer to "Finding the correct
settings" on page 17.
NOTICE
• Loud volume levels over prolonged periods of time can cause permanent damage
to your hearing!
DSC 1
Changing the level
FLAT
Press
level has been reached. Each short, momentary press will increase the volume
o level with 1 dB.
90
Press
PHASE
desired level has been reached. Each short, momentary press will decrease the
o
o
volume level with 1 dB.
180
Note
• Together with the other settings, the volume level can be stored in one of the four
D
presets. Refer to "Storing and Recalling Presets (PRESET)" on page 14. Together
with the other settings cross-over frequency and phase we recommend that, once
found, you store the optimum volume level into one of the presets.
• The volume control is disabled when the subwoofer is set to Slave mode (refer also
to "Master and Slave mode" on page 7).
Setting the cross-over frequency (CROSSOVER
FREQUENCY)
The cross-over frequency can be set to four positions:
FLAT. The roll-off slope is 24 dB per octave. In most cases, selecting cross-over
frequencies is done through the bass-management system of your processor or
receiver. In this case, use the
processor or receiver how to set the cross-over frequency.
DSC 1
Selecting the cross-over frequency:
Press the button for the desired position. When pressing the button, ensure that
FLAT
the command from the remote control is received.
Check the operating guide of the other speakers in the system if a specific frequency
is recommended. Please refer to "Finding the correct settings" on page 17 for more
o
90
information.
PHASE
Note
o
180
Together with the other settings, the cross-over frequency can be stored in one of the
four presets (refer to "Storing and Recalling Presets (PRESET)" on page 14).
Together with the other settings volume and phase we recommend that, once found,
D
you store the correct cross-over frequency into one of the presets.
The CROSSOVER FREQUENCY
Slave
LEVEL + to increase the volume of the subwoofer, release when the desired
LEVEL – to decrease the volume of the subwoofer, release when the
FLAT
control is disabled when the subwoofer is set to
mode (refer also to "Master and Slave mode" on page 7).
60 Hz, 80 Hz, 100 Hz
position. Refer to the operating guide of the
Dynaudio SUB 300/500
and