Replacing The Batteries; Operation - Hama RC 200 Bedienungsanleitung

• Immediately remove and dispose of dead batteries from the product.
• Avoid storing, charging or using batteries in extreme temperatures.
4. Getting Started
4.1. Inserting the batteries
• Open the battery compartment (14) and remove the contact breaker. Replace the battery compartment cover.

4.2. Replacing the batteries

• Open the battery compartment (14), remove and properly dispose of the dead batteries and insert two new
AAA batteries with the correct polarity. Replace the battery compartment cover.

5. Operation

Note
Hold down the ▲ button (13) or the  button (12) to select the values faster.
• Press the MODE button (11) repeatedly to switch between the following displays:
• Temperature
• Alarm mode 1 (ALM1)
• Alarm mode 2 (ALM2)
• Dual Time
5.1. Automatic date/time setting using the DCF signal
• Once you have inserted the batteries, the display is switched on, an acoustic signal sounds and the alarm
clock automatically starts searching for a DCF radio signal. During the search, the radio icon (6) will flash.
This process can take 3 to 5 minutes.
• When the wireless signal is received, the date and time are automatically set.
Not displayed
• Press and hold the °C/°F/WAVE button (10) for approx. 3 seconds to start a manual search for the DCF radio signal.
4
Display
Display flashing
Display steady
Searching for the DCF signal
Active
Successful - signal reception
Inactive – no signal reception