Accessories; Maintenance - Femi NG 160 Gebrauchsanleitungen Und Wartung

4.6 CORRECT POSITIONING OF THE PIECE IN
THE CLAMP (Fig. 11)
The pieces to be cut should be fitted directly between the
jaws without adding other objects.
ATTENTION: Never hold the pieces to be cut in
your hand.
(Fig. 11)
When the pieces to be cut are profiled sections, flat pieces
or special shapes, refer to the examples shown in the
figures.
If the thickness of the profiled section is to be very thin,
an outline should be fitted which copies the profile inside
the profiled section itself to stop it being crushed between
the jaws.
4.7 CUTTING TABLE
5

ACCESSORIES

5.1 CHOISE OF BLADE
Your sawing machine is equipped with a bi-metal blade
measuring 1735x13x0,9 mm with variable toothing 6/10
teeth per inch, for use in the majority of cuts possible with
this machine. For special requirements (see cutting table
point 4.7), for example, for cutting large solid sections or
profiled sections or corner pieces of small thickness, there
are also blades avail-able with 4/6 toothing or 14 teeth per
inch.
MATERIAL:..............M42 (steel for springs ÷ steel HSS)
EXTENSION: .............................................. mm 1735
HEIGHT: .........................................................mm 13
THICKNESS: .................................................mm 0,9
TOOTHING: ..........................................standard 6/10
5.2
The fasten the machine to the base plate, use the four
screw A, four nuts B and four Washer C conteined in yhe
carton box of the base plate.
Put the four screws A into the holes of the base of the
machine, and fasten the whole with the four nuts B.
6
6.1
The operations of ordinary maintenance, which may also
be performed by non-specialist personnel, are all described
in the previous sections and here below.
1. Before performing any maintenance operation,
disconnect the machine electric plug from the wall
outlet.
2. During maintenance operations, always wear personal
protection (safety goggles and gloves).
3. Remove the processing residues from the cutting
area and the blade guides whenever necessary.
You are advised to use a suction device or a brush.
If you do not intend to use the sawing machine for a long
time, clean it and put it in a dry place if possible.
In these cases it is advisable to slacken off the blade so
that it is not kept tight for no reason.
6.2
Should it be necessary to call qualified personnel for
operations of extraordinary maintenance, or in the case
of repairs, under guarantee or at a later date, you should
always contact an authorized service centre or the factory
directly, if there is no service centre in your area.
6.3
At the end of the machine life, if the
machine must be scraped, contact
an authorised waste disposal centre
in order to comply with the Standards
for hygiene and environment
safeguard.
The packing must be disposed of
according to the ruling standards by
delivering it to authorised people for
the collection, disposal or reclaim.
Please contact the ASSOCIATION OF USED OILS near
to you.
optional 4/6 - 14
FITTING THE BASE PLATE (Fig. 3)
(where included)

MAINTENANCE

REGULAR MAINTENANCE
ATTENTION: Do not use jets of compressed air
.
ASSISTENCE
DISPOSAL OF THE MACHINE, PACKING
2002/96/EC
13