Embedded Type; Screw - Panasonic CZ-RTC5 Einbauanleitung

Preparation: Make 2 holes for screws using a driver.
3
Mount the top case.
Align the claws of the
top case and then
align the claws of the
bottom case.
Avoid the
wire being
caught.
Claw (2 places)
2
Connect the remote control
wiring
Dimensions

Embedded type

1
Mount the bottom case to the wall.
Pass the wire through the hole in the centre
of the bottom case.
Hole for screw

Screw

Claw (2 places)
(Supplied)
Bottom case
(Back side)
120
120
Remote controller terminal board
Top case Remove the coating. Approx. 6 mm
(Back side)
Make sure the wiring connection is
in the correct direction.
23 23
16
5-5x9
(mm)
9
(EN)