ECG VP 4121 BS eco Bedienungsanleitung Seite 36

VACUUM CLEANER ASSEMBLY
• Before you begin with the assembly of the vacuum cleaner, ensure all components and accessories were
included in the package, see list of parts.
• The vacuum cleaner must be switched off and unplugged prior to the
assembly.
Connecting the hose to the vacuum cleaner
Insert the hose horizontally into the suction hole on the vacuum cleaner
unit, as shown on the following image.
Make sure the orientation of the two stubs is correct. Once the hose is fully
inserted, turn the hose to the right. A clicking sound indicates the hose is
properly secured.
Attaching and removing the dust container
Place the bottom of the dust container onto the stub in the front part of the
vacuum cleaner unit and press down. A clicking sound the dust container is
properly secured in the lock on the vacuum cleaner unit.
To remove the container, press the lock on the container handle. The container
can be removed from the vacuum cleaner while holding the lock.
Telescopic tube and fl oor brush assembly
Insert the front end of the tube grip handle into the metal telescopic tube. Insert the other end of the telescopic
tube into the round opening of the fl oor brush and adjust properly. You are now fi nished with the vacuum
cleaner assembly.
OPERATING INSTRUCTIONS
Let's start
1. First of all, unwind the necessary length of the power cord from the reel. The yellow symbol on the power
cord indicates the optimal unwinding length. Do not unwind the cord past the red symbol.
2. Plug the power cord into the electric outlet. Turn on the vacuum cleaner.
Suction power control
High suction power causing the suction, of e.g. textile into the brush and tube, can be
regulated by the suction power control on the grip handle, see image.
Thermal protection for the motor
1. Thermal protection is found inside the motor area, which can automatically
disconnect the power supply to the motor and prevent overheating. The
temperature of the motor increases in case the motor is overloaded or the suction or air vents are clogged.
Upon reaching a specifi c threshold, the protection automatically disconnects the power supply to the
EN
motor, allowing it to cool down and prevent damage.
2. If the protection disconnects the power supply to the motor, immediately switch the vacuum cleaner off
and unplug the power cord from the outlet. Allow the vacuum cleaner to cool down and remove the
impurities blocking the suction (as well as the hose and grip handle) and if necessary, replace the HEPA
fi lter or felted fi lter.
36