Icy Box IB-RD3252 Benutzerhandbuch Seite 31

http://www.icybox.de
Dual-Bay RAID Storage Enclosure
for two 3.5-inch Serial ATA
Hard Drives
3.5 Display Information
In addition to the details about the hardware and device
certain event information. Following is a list of possible messages and their meanings.
[HDD Error / Remaining 1xHDD]
When using RAID 0 and one of the drives fails, the alarm will go
only one good drive remains. Refer to the HDD LED's in order to locate the defective drive.
[RAID Warning / Degraded Array]
When using RAID 1 and one of the drives fails, the alarm will go
message. Press the [OK] button to temporarily mute the alarm and use the HDD LED's in order to
locate the defective drive.
[XX Cable / Connected]
Shows which cable has been connected.
[Cable / Disconnected]
Shows when the cable has been unplugged.
[Rebuilding... / Hrs left xhxxmin]
Shows during the rebuild process of a RAID 1 array with an approximate time in hours and minutes
indicating how long it takes until the backup is done.
[Alarm / High Temperature] Indicates critical temperature (>60C)
[Alarm / Fan Failure] Indicates a fan failure or unexpectedly slow RPM.
[Detecting Disk / Starting...]
Shows during start up of the system.
[XX / Starting ...]
Shows during start up of the system.
[Check DIP Switch] Shows when trying to change the RAID mode via LCM display but the DIP switch
is set to a
[RAID Mode Locked]
Shows when trying to change the RAID mode but the RAID switch is still in the locked position.
IB-RD3252
RAID mode already.
29
the LCD display will also show
and the display indicates that
and the display shows this