Herunterladen Inhalt Inhalt Diese Seite drucken

Waeco PerfectCharge IU1512 Bedienungsanleitung Seite 40

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
_900_serie.book Seite 40 Mittwoch, 22. März 2006 4:28 16
Installation
Temperature sensor (can be obtained from WAECO as accessory)
The temperature sensor measures the temperature at the battery or in the
environment of the battery and transfers it to the IU0U automatic charger.
The charging voltages indicated in Chapter „Technical data" on page 47 refer
to an ambient temperature of 15 °C to 25 °C. With deviating temperatures,
the charging voltage is increased or decreased according to the diagram on
page 43.
➤ Lay the cables from the batteries to the IU0U automatic charger.
➤ Connect the temperature sensor to the rear of the IU0U automatic charger
(see figure 14, page 7) via the socket.
➤ Fasten the sensor head directly to the battery. Use e.g. double-sided
adhesive tape for this and attach the sensor to the upper side of the
battery or in the vicinity of the battery.
➤ Switch the IU0U automatic charger "OFF" and "ON" again to activate the
temperature sensor.
Remote control (can be obtained from WAECO as accessory)
The remote control serves for switching ON and OFF and for the functional
check (see Chapter „Functional check" on page 44) of the IU0U automatic
charger
Note
Attach the remote control at a well accessible place to ensure an
optimal remote control and check of the IU0U automatic charger.
Caution!
Pay attention when attaching the remote control (when drilling and
screwing) to the course of the available, particularly non-visible
wiring harnesses, cables and other components which are in the
assembly range!
➤ Lay the cables from the batteries to the IU0U automatic charger.
➤ Make an oblong convexity in the assembly surface with approx. 50 mm
width, 55 m height and 23 mm depth for the take-up of the remote control.
➤ Connect the remote control on the rear with the intended connection (see
Chapter „Specifications of the unit variants" on page 33) via the bush at
the IU0U automatic charger. The connection cable is equipped with two
equivalently allocated modular plugs.
40
IU0U automatic charger

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis