Installation - SOLAC ESPRESSION SUPREMMA CA 4815 Gebrauchsanleitung

9 INSTALLATION

If you find coffee grounds, it is because the coffee-maker has
been tested to make sure it works perfectly.
Before switching on the coffee-maker, make sure you have
removed the protection from the screen.
1. Fill the coffee bean tank with coffee beans (the tank has a
capacity for up to 250 g).
2. Fill the water tank with clean, cool water. You can fill it di-
rectly (a) or under the tap (b)
a) Lift the water
tank cover.
When placing the tank back in position, make sure it fits into
the flap on the body, so that it is perfectly in place.
3. Connect the power cable.
4. Turn on the on/off switch at the rear of the coffee-maker.
Turn it to the "I" position to switch the coffee-maker on.
5. The standby button will come on (blue).
b) Remove the tank by
the handle.
6. The first time you use the coffee-maker, its internal cir-
cuits need to be filled with water. The steam jet/hot water
regulator icon appears on the LCD screen to indicate that
the circuit needs to be filled.
IMPORTANT! Perform this operation BEFORE any other.
IMPORTANT! The circuit must be filled each time the steam
regulator icon appears on the display. This icon appears each
time the machine is PLUGGED IN.
7. Place a compartment (glass or jug) under the steam noz-
zle.
8. To fill the circuits with water, turn the steam regulator
anticlockwise as far as it will go.
9. Wait until water or steam comes out of the steam noz-
zle.
10. Close the steam regulator to complete the circuit filling
process.
11. Remove the compartment with the hot water.
12. The coffee-maker will turn off and is ready for use. Press
the standby button.
13. An hourglass will appear on the display to indicate that
the system is heating up.
14. The coffee-maker auto-cleans the pipes to remove pos-
sible remains of coffee or water. During this process, wa-
ter comes out of the coffee outlet. This enables you enjoy
a coffee made with clean, fresh water.
6