Werbung
Verfügbare Sprachen
Verfügbare Sprachen
g Operating Instruction
Safety notes:
1. Read all instructions thoroughly before using the
machine.
2. Place the cable in such a way that no one will trip
over it.
3. Never open the housing of the laminator.
4. Do not operate the device if it is wet.
5. Switch the device off after use and remove the plug
from the power supply when the device is not in use.
6. Do not cover the heat openings during use.
7. Do not touch the heat openings during or directly
after operation -> Danger of burns!
8. Do not insert any objects into the device (including
into the heat openings) except the designated fi lm.
9. If the cable, housing, or socket is damaged, do not
use the machine.
10. Wait approx. 3-5 seconds for the fi lm to cool down
before touching it -> Film may be hot!
11. Do not laminate any liquids, gelatins, or other moist
substances that could leak.
Operating instructions:
Before laminating, it is recommended that you carry out
a test lamination to familiarize yourself with the device
and to test that the device is working properly.
1. Remove all packaging materials from the device.
2. Place the laminator on a stable, even surface.
3. Connect the power cable to a
220-240 V~ outlet.
4. Select the lamination thickness -
80 or 125 mic (depending on the thickness
of the laminate sleeve) and move the
switch to the correct position. This
ensures that the lamination is sized to the
appropriate thickness.
5. To switch the device on, press the On/Off button on
the right-hand side. The red „Power" light will go on
to show that power supply is functioning.
6. The laminator takes 8-12 minutes to warm
up. The „Ready" light turns green when the
laminator is ready to be used.
7. Place the document to be laminated in the
appropriate laminate sleeve, as shown in the
illustration below. Leave approx. 3-5 mm of free
space at the corners of the sleeve. Ensure that there
is no dust or dirt in the laminate sleeve.
8. Begin the lamination process. Insert the laminate
fi lm in the middle and the sealed side fi rst into the
front of the device. The fi lm automatically passes
through the device.
9. Do not remove the fi lm until the lamination is
complete (when the fi lm has completely passed
through the machine).
10. Switch the device off after use and remove the plug
from the power supply when the device is not in use.
Technical specifi cations:
• Power connection:
• Power consumption:
• Max. sleeve thickness:
• Max. lamination width
• Max. lamination height
• Warm-up time:
• Lamination speed:
220-240 V~
120 W
80 µ / 125 µ
340 mm
0.4 mm
8-12 minutes
300 mm/min.
3
Werbung
