Fitting The Wall-Mounting Bracket; Charging The Vacuum Cleaner - Team KS 15 Gebrauchsanleitung

Fax +32 2 359 95 50

Please read, follow and save this instruction manual. Before using your vacuum cleaner for the
first time, charge the accumulator during approximately 16 hours. A fully charged accumulator
will give approximately 10 to 12 minutes vacuum cleaning.
UK STYLE PLUG WIRING INSTRUCTIONS (IN THE UK ONLY)
This product must only be used from a 13 amp power socket.
The plug is also a transformer for the battery charging system, and is not a home serviceable
item. Do not use if the plug/transformer has been damaged in any way.

FITTING THE WALL-MOUNTING BRACKET

Fit the plug of the charger into the wall bracket and then turn 90° to lock it in position (see
Figure 1). The wall bracket is now ready for storing and for recharging your vacuum cleaner.
MOUNTING THE WALL-MOUNTING BRACKET (see Figure 2)
Select a point in the vicinity of a wall socket, indoors and not subject to damp. Position the
bracket against the wall placing the open part to the top and mark the points at which the
fastening screws are to be inserted. Using a 5 mm diameter drill, drill two holes, insert the plastic
plug. Then screw in the screws until only the last 5 mm is still protruding.
Then hang the bracket on the screws, and tighten the screws up to their full extent. Check that
the cable is not pinched. It should pass through one of the recesses in the wall bracket.

CHARGING THE VACUUM CLEANER

The adaptor should only be connected to a 230V, 50Hz power supply.
Caution: The charger and its cord cannot be repaired. Should they be damaged, they must be
thrown out. Contact the customer service to replace them. Put the plug into a 230V wall
socket and insert the vacuum cleaner in the bracket (the handle should be at the bottom).
The charging indicator will come on which means that the vacuum cleaner is correctly
positioned and that the recharging will start. The charging indicator remains lit, even when the
accumulator is fully recharged.
You can keep your vacuum cleaner in its charging holder during long periods, there will be no
risk of damage.
NOTE: Charging should not be carried out when the ambient temperature is below 0°C or
above +40°C. The charger will become warm during use. This is perfectly normal.
USE
Holding the handle remove your vacuum cleaner from its bracket. Switch on the vacuum
cleaner by pressing the switch to the "ON" position. Tilt the vacuum cleaner till the nozzle of the
dust collector is placed horizontally compared to the surface that is to be cleaned. When you
are finished, release the ON/OFF switch and the appliance will be switched off.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
6
Assembly page 6/12