Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Instructions; Initial Operation - Oase AQUAMAX 4000 Gebrauchsanweisung

Vorschau ausblenden Andere Handbücher für AQUAMAX 4000:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

4. Safety Instructions

Power connection
The combination of water and electricity can result in serious hazard to life and
limb in the case of improper electrical connection or improper handling.
– For your own safety, please contact an electrical specialist for questions and
– Caution! The device may not be operated if cable or housing is defective!
– Caution! Do not operate the device if there are people in the water Unplug
– Caution! Always unplug the power plugs of all devices in the water before
– Compare the supply voltage (V) and the supply frequency (Hz) of your mains
– Only operate the device from a power outlet installed as prescribed by directive
– Never use installations, adapters, extension or power cords without earthing
– Insure that the device is supplied via residual power protection circuit with a
– Electrical installations for garden ponds must correspond to the international
– Never pull the device or carry the device by the power cord.
– Keep the power plug and all connecting points dry!
– Lay out the power cord so that it is protected, and that the possibility of
– If you require an extension cord: Only use cable that is approved for outdoor
Operating Instructions
– Caution! Always unplug the power plug before opening the filter shell for
– Never pump any liquid other than water!
– Never operate the pump without water (dry-run). The pump bearings will be
– Ensure that the pump is in a stable position before switching it on.

5. Initial Operation

– Strictly observe the safety instructions in section 4.
– Fasten a hauling rope to the pump. This enables you to pull the pump out of the
– The pump starts automatically as soon as you connect the power cord.
12
Aquamax4000-16000.p65
GB
Operating instructions
problems!
power plug!
reaching into the water.
power with the data on the nameplate. These data must agree.
with protective earthing.
contact!
rated residual current of maximum 30 mA.
and national construction determinations.
damage is excluded.
use. Protect the plug connection from moisture.
maintenance and cleaning.
destroyed!
water if required.
Therefore completely assemble the pump and the satellite filter and set it up
correctly before connecting it to the mains power.
12
GB
10.05.2004, 16:02

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis