Oase AQUAMAX 4000 Gebrauchsanweisung Seite 15

Disassembly and cleaning (Fig. 3):
1. Unplug power plug.
2. Take the filter shell with the pump out of the pond using the hauling rope. Do
3. Unscrew the threaded collar on the hose to the satellite filter.
4. Remove the stepped hose adapter together with the hose to the satellite filter.
5. Unscrew the threaded collar on the hose to the water filter.
6. Remove the stepped hose adapter together with the hose to the water filter.
7. Open the filter shell by pressing the engagement points in on both sides of the
8. Take the pump out (8) of the filter shell.
9. Take the inlet adjustment (6) from its guide (7).
10.Unscrew the pump housing.
11.If necessary, clean the impeller with a brush. If the rotor is damaged, then do
12.Clean the filter shells (1,4), the stepped hose adapter (2) and the inlet regulator
Assembly after cleaning
1. Unscrew the pump housing again.
2. Replace the inlet regulator (6) by pushing it on its guide (7).
3. Place the pump (8) in the filter shell mountings provided for it (1). Ensure that
4. Close the filter shell and press together on the two engagement points, until
5. Firmly tighten the threaded collar on the stepped hose adapter of the inlet
6. Firmly tighten the threaded collar on the stepped hose adapter of the pump
7. Return the pump with filter shell to the pond.
8. Plug the power plug into a wall outlet. The pump will start automatically.
8. Winter care
– The filter feed pump is frost-proof. Thus it can remain in the water during the
– Before starting the pump for the new season, check all parts for damage,
– If you take the pump out of the pond in the winter, then you must store it in a
– Never immerse the power plug under water.
Aquamax4000-16000.p65
GB Operating instructions
not lift the pump by the power cord.
discharge opening to the water filter and then open the filter shell.
not replace it yourself; rather take the pump to your authorized dealer for
repair.
(6) with clean water and a brush.
the inlet regulator is correctly seated in its guide rail in the filter shell, and that
the power cord is correctly positioned in the opening provided (9).
they audibly click into place.
regulator (6).
discharge (5).
winter.
particularly the lines.
container with water. This prevents debris from settling and the gaskets will
remain intact.
15
GB
10.05.2004, 16:02
15