Installation - Livin Flame Bern Montageanleitung Und Gebrauchsanweisung

Assembly instructions and operating manual
Congratulations with the purchase of your bio-ethanol fireplace. You now own a quality product that will
provide a cosy atmosphere and many years of enjoyment with proper use.
Benefits of bio-ethanol fireplaces:
- Real flames
- Wide fire
- Heat
- Easy to install
- Maintenance-friendly
- No special provisions, such as flue tubes, are necessary.
- Virtually no emission of pollutants, especially compared to gel en wood fireplaces, for example.

Installation

Bio-ethanol fireplaces can be installed almost anywhere – in the living room, of course, but also in a
bedroom (live-in) kitchen, in a chalet or mobile home.
The fireplace was designed as a suspension installation. Place the fireplace in a minimum space of 32 cubic
meters (Width x Length x Height of the room). Be sure that the space in which the fireplace is placed has
sufficient ventilation for the fireplace, which can be distributed across several ventilation openings.
One benefit of bio-ethanol fireplaces is that they are easy to install and relocate. If you change your
interior arrangement, you can easily position the fireplace in another location. The investment in a
bio-ethanol fireplace is also low, certainly compared to traditional fireplaces and fires. Besides adding
atmosphere, the bio-ethanol fireplace provides a pleasant source of supplemental heating. However, the
fireplace was not designed as a primary source of heat.
Assembly
- It's recommended at least 2 or more people
install the fireplace.
- Before installation, remove the packaging and
check to see whether the fireplace is damage free.
If this is not the case, you should contact the
purchasing address.
- Do not remove the non-flammable panel from the
back of the fireplace.
- Only install the fireplace on a vertical, solid, stable
and non-flammable rear wall.
- Determine the location in the space where the
fireplace should be suspended.
- Only install the fireplace in a minimum space of 32 cubic metres.
- The fire must be hang solid and stable. Before installing the fire, the supplied assembly set has to
be used. The assembly consisting of a flat strip with two hooks, two angle strips with a square
opening, screws and plugs.
- The flat strip, with the hooks upward direction, should be fixed horizontally on the wall. Use the
included level, screws and plugs.
- Hang up the two angle strips vertically with the square holes over the back hooks. The corners are
pointing towards you. Screw the angle strips to the wall.
- At the back of the fireplace are two square openings. Hang up the fireplace to the horizontal strip.
Make sure the two hooks of the strip hang up in the square hole of the fire. Then, screw the fire at
the bottom to the angle strips.
- Place the reservoir in the fireplace with the filling hole at the back.
- As a result of heat formation around the fireplace, the background could start to discolour slightly
over time.
- Keep inflammable material at least 50-cm away from the fireplace.
ENG-2