Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Getting started
-
Remove the appliance from the box.
-
Remove any packaging from the product.
-
Place the packaging inside the box and either store or dispose of safely.
Contents of Carton
-
Electric fireplace
-
Fixing screws and side decorative brackets
-
Remote control
-
Instruction Manual
Helpful Advice Before Fitting
-
Please retain all packaging until you have checked and counted all the parts and the contents of
the fixing pack against the parts list.
-
Do not use this appliance if any part has been under water. Immediately call a qualified
service technician to inspect and to replace any part of the electrical system if necessary.
-
Keep little children away before and during installation. Be aware that the little children do not
be in contact with the parts.
-
The electric fireplace can be installed almost anywhere in your home. Please, read and follow the
instructions carefully by choosing a location. For the best result, install the electric fireplace not in
direct sunlight.
Tools required
-
Magnetic Phillips Screw Driver
Installation
-
It's recommended at least 2 or more people install the fireplace.
-
Do not switch the appliance on until it properly installed as described in this manual.
-
Do not place the electric fire directly on carpets. This to avoid possible discolouring caused by
the heat or blockage of air inlets.
-
The electric fireplace should be located close to a suitable mains socket to enable connection. The
electrical socket must be easily accessible to allow disconnection.
-
Installation:
Take out side decorative brackets
and ST4×8 screws.
Put the side decorative brackets at the right place
as above picture. Pay attention to the direction.
ENG-3
Werbung
Inhaltsverzeichnis
