Cleaning; Maintenance; Warning On Using Full Power - Lacor 69132 Gebrauchs- Und Instandhaltungsanleitung

1.- Always turn off and unplug the appliance before cleaning it. Wait until it is at room
temperature.
2.- Never use any chemical or abrasive products. Do not use a brush or any other type of
utensils which could damage the different parts and surface of the slicer.
3.- Use a damp cloth with detergent to clean the machine and then dry it. Make sure to clean
the machine completely every day.
4.- ATTENTION: Do not put the machine directly into any container with water in it.
This machine is not waterproof.
The induction plaque does not require special maintenance, but the following precautions
should be taken:
a- Do not leave the grinder running unsupervised; the engine overheating may reduce
its operating lifespan and/or generate irreparable damage.
b- Only use original spare parts; the use of parts supplied by other manufacturers
may permanently damage the machine.
c- If you do not use the grinder for long periods of time, we recommend applying a
thin layer of oil over the complete surface, even on the stainless steel tray.
d.- Do not obstruct the ventilator's air outflow located at the back. Excessive heating
may cause irreversible damage to the plaque.
e - Avoid banging on the surface of the plaque, for the glass may crack, especially
when it is hot.
For security reasons the plate has an automatic switch off system in case of overheating, so
you should take caution when using full power, according to the following precautionary
measures:
a.- Only use full power for cooking a large amount of food or liquids to be heated.
b.- Do not use the maximum power for heating small amounts, don't transfer heat to
food, the frying pan or saucepan pan used will overheat, transmitting the heat to
the induction plate which turns off displaying the E02 error.
c.- Do not use the plate at full power for longer than 45 minutes, reaching the point of
boiling or baking, reduce the power to prevent overheating.
d.- For security reasons the plate will switch off automatically after 3 hours regardless
of power level used.
In case of overheating, turn the plate and allow this to cool before reusing.

MAINTENANCE

WARNING ON USING FULL POWER

CLEANING

25