Cleaning / Maintenance; Cleaning & Maintenance - Lacor DUAL Gebrauchs- Und Instandhaltungsanleitung

b) Power + time: This function enables you to set the operating time of the hob at the
previously defined power. The maximum programmable time for both sides is
180 minutes, with intervals of 5 minutes.
c) Temperature: This function allows you to set the temperature you wish to cook at.
The temperature levels that can be set are: 60 - 80 - 100 - 120 - 140 - 160 - 180 - 200
- 220 - 240 ºC
d) Temperature + time: This function enables you to set the operating time of the hob
at the previously defined temperature. The maximum programmable time for both
sides is 180 minutes, with intervals of 5 minutes.
Note:
Use the increase and decrease buttons on the left side (b and c) and the
right side (g and h) to change the programming of the previous functions.
8.- Once the working conditions have been set, it is possible to independently lock the hobs in
order to prevent changes to their programming.
To do this, press the lock button (a and f) on the corresponding side. A red light will indicate
that the control is locked.
9.- To unlock the controls, press the corresponding lock button for 3 seconds..
10.- After you have finished using it, press the "ON/OFF" button to turn off the hob.

CLEANING / MAINTENANCE

1.- Please unplug the cooker before cleaning, after the plate isn't hot, you can start
cleaning.
2.- The dust around the air entry and air vent can be cleaned lightly with flexible dry cloth or a
flexible brush or cleaner.
3.- The slight dirt on the panel: please clean with soft wet cloth.
4.- The oily dirt: clean with soft wet cloth dipped in little toothpaste or neutral detergent and
clean with soft wet cloth until no residue exists.
Troubleshooting Guide
1.- Power cord replacement
If the power cord is damaged, please contact the relevant after-sale service agent, who will
dispatch personnel for the repair. For the purpose of your safety, please never replace it by
yourself.
2.- Trouble shooting
If an abnormality comes up, the induction hotplate will enter the protective state automatically and
display corresponding protective codes:
Error Message
E0 Cause: No cookware or the cookware is not suitable for the induction cooker.
Solution: Put the suitable cookware on the cooking zone.
41