Operation - Lacor 69132 Gebrauchs- Und Instandhaltungsanleitung

1.- Take out the machine and all its accessories and take off the wrapping before you use the
electrical appliance. Do not throw away the wrapping until you have checked that the
appliance functions properly.
2.- Ensure that you place the appliance on a hard, flat surface. Avoid contact with excessively
hot areas or other dangerous elements. Check that the connection wire and the power point
are in perfect condition.
3.- Make sure that there is a space around the appliance of more than 30 cm on each side,
especially at the front (the user's area).
4.- Before you switch the appliance on for the first time, clean the surface and the frame of the
plaque with soapy water and then dry them. Remember that the plaque must not be
submerged in water.
5.- Connect the plug to the socket according to the values indicated in this manual. The light on
the "ON/OFF" button will flash while the plaque is connected.
6.- Press the "ON/OFF" button. If you do not place any metal element apt for induction use, the
plaque will give out an intermittent BEEPING sound warning you. If after 30 seconds you do
not place this element, the plaque will turn off automatically.
7.- Once the frying pan or saucepan is placed, it will start to heat up. The initial power will be by
default 2,000W (100ºC). Press the buttons with arrows to decrease or increase the power
(temperature).
8.- At any moment when heating or cooking, you can press the "TEMP/HEATING" button which
will allow you to alternate between the information shown on the screen in power "W" or in
temperature "ºC". By default, the value shown is power.
9.- When power is selected as the value, the red light next to the word "HEATING" will come on.
When control is done through the temperature, the light next to the word "TEMP" will come
on.
10.- Set the cooking time.
a.- Select the desired level of power or temperature by pressing the up and down buttons.
b.- Press the button "TIMER".
c.- Press the button with the up arrow to set the cooking time up to a maximum of 180
minutes. If you need to, use the down arrow to correct the cooking time.
d.- Press the "TIMER" button again to set the time. Once the cooking time is up, the
plaque will BEEP 5 times and will then switch off automatically.
11.- Once you have finished using the appliance, press the "ON/OFF" button to turn off the
plaque. The ventilator will continue to function for a few seconds to prevent heat bags
inside the plaque.

OPERATION

24