Cleaning; Maintenance - Lacor 69033 Gebrauchs- Und Instandhaltungsanleitung

1.- Always turn off and unplug the appliance before cleaning it. Wait until it is at room
temperature.
2.- Never use any chemical or abrasive products. Do not use a brush or any other type of
utensils which could damage the different parts and surface of the slicer.
3.- Use a damp cloth with detergent to clean the machine and then dry it. Make sure to clean
the machine completely every day.
4.- ATTENTION: Do not put the machine directly into any container with water in it.
This machine is not waterproof.
The induction plaque does not require special maintenance, but the following precautions
should be taken:
a- Do not leave the grinder running unsupervised; the engine overheating may reduce its
operating lifespan and/or generate irreparable damage.
b- Only use original spare parts; the use of parts supplied by other manufacturers may
permanently damage the machine.
c- If you do not use the grinder for long periods of time, we recommend applying a thin
layer of oil over the complete surface, even on the stainless steel tray.
d.- Do not obstruct the ventilator's air outflow located at the back. Excessive heating may
cause irreversible damage to the plaque.
e - Avoid banging on the surface of the plaque, for the glass may crack, especially when it
is hot.
34

CLEANING

MAINTENANCE