Maintenance Overview; Decommissioning And Disposal - Pentair Water 5TPE Montage- Und Betriebsanweisung

8.4 Maintenance overview

Various maintenance work and checks must be carried out
during the working life of the pumps. This chapter specifies
the relevant maintenance intervals.
The maintenance intervals should be reduced accordingly
in the event of harsher usage or environmental conditions.
Component
Warning pictograms
Water supply
Safety devices
General condition of
pumps
Cooling ribs of
electric motors
Electrical equipment
Preliminary filter
housing
O-ring in preliminary
filter cover
Procedure:
C = Check
9. Decommissioning
and disposal
All electrical components must be disconnected
from the power supply and completely
discharged before dismantling.
Ensure that no leaks occur after disconnection.
Check
Visual check
Check lines and connections
for leaks
Visual check
Visual check
Clean the cooling ribs to maintain
the cooling effect
Check
Check housing for dirt
Visual check
CL = Clean
L = Lubricate
Proceed as follows for the performance of maintenance
work:
Read the relevant technical documentation thoroughly
(if available), and follow the instructions given there.
If no particular procedure is specified, ensure that the
necessary work is carried out properly.
Procedure Interval
C
C
C
C
CL
C
CL
C / L
Interval:
w = weekly
9.1 Disposal
The following must be carried out:
ü Remove and destroy the rating plate with the CE symbol
ü Complete disposal or recycling of the pumps
9.2 Environmental compatibility
Ensure safe and environmental disposal of the
materials used. Applicable national regulations
must be followed.
23
> <
Remarks
m Replace if necessary
m Repair any damage
immediately
m Ensure correct installation /
refitting
h Look out for any corrosion
or damage
h
m Rectify loose connections or
singed cables immediately.
Have all faults repaired by a
qualified electrician
w Remove all dirt thoroughly
h
m = monthly
h = half-yearly