Herunterladen Inhalt Inhalt Diese Seite drucken

Control Panel - Schumacher PWI70300A Benutzeranleitung

Automatisches batterieladegerät
Vorschau ausblenden Andere Handbücher für PWI70300A:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 26
1. Carefully lay the charger on its front to prepare for assembly.
2. Assemble the foot (Item 6) using two ¼-20 screws (Item 5) and tighten securely.
3. Attach the two axle brackets (Item 1) using one 10-32 screw (Item 4) in each. The
brackets should have one end hooked into the slot in the charger base. Be careful
not to drop the brackets inside of the charger case. Do not completely tighten the
screws (Item 4) at this time.
4. Slide the axle (Item 2) into the brackets (Item 1) until centered on the charger.
5. Slide one wheel (Item 3) onto the axle with the recessed hub facing out as shown.
6. Insert the pin (Item 8) through the axle hole.
7. Repeat this process for the other wheel and when both wheels have been pinned
8. Snap the axle caps (Item 7) onto each wheel to cover the pin and axle.
9. Lift the charger upright so that it rests on the wheels and foot.
10. Remove the two top side screws (Item 9) from each side of the charger.
11. Verify that the foam handle grip (Item 12) is on the handle assembly (Item 10).
Install if needed.
12.
handle (Item 10).
13. Align the handle assembly (Item 10) with charger and reinstall the side screws
(Item 9). Do not over tighten.
14. The charger assembly is now complete. The battery clips can be clamped to the
15. Do not attach the clips to the foam area of the handle; this will damage the
foam grip.
10.

CONTROL PANEL

Timer
Timer Setting:
time for charging. After the timer expires, the charger
stops charging your battery. The main function of the timer
is to prevent overcharging while allowing a battery time
to obtain a satisfactory charge. To properly set the timer,
you must know the size of the battery in ampere hours
or reserve capacity in minutes and the state of charge. It
is important that you determine the appropriate state of
the timer accordingly.
24H (Hold): This position defeats the timer function, allowing for continuous operation.
Put the timer in the 24H position when you want to charge more than 2¼ hours.
WARNING
charged. Not doing so may cause damage to your battery or may cause other personal
property damage or personal injury.
Be sure to monitor the charging progress and stop it when the battery is
6
12
10
11
9

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis