Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Bedienungsanleitung / User manual
VCHD-1622 / VCHD-2622 / VCHD-4322IR / VCHD-2792IR
3. Adjustments
The camera is equipped with an additioanl video connector (PAL). You can use it in
combination with the included adapter, e.g. for connecting a monitor during the installation
phase.
Note: This only applies to PAL signals.
Please also see chapter 5 "Camera adjustments via OSD menu" for further details
3.1 VCHD-1622
The camera housing must not be opened! All camera adjustments are accessible from the
outside.
On the camera rear there is a little joystick. Press onto this joystick and an OSD menu pops
up in the video picture. You can now move the joystick left/right/up/down in order to get to the
desired menu item. To confirm your choice, press onto the joystick.
3.2 VCHD-2792IR
At the bottom of the camera there is a small lid. Open the lid carefully by turning it left. Below
the lid you will find a mini-joystick for the OSD control, a switch for adjusting the brightness of
the IR-LEDs and an additional video output for service purposes (connection is being done
by the included adapter).
Once all adjustments are being made, close the lid again. Please make sure that the rubber
gasket is not damaged.
Sunshield:
Ensure to correctly install the sunshield. The inside front of the sunshield has a black anti-
reflex foil. The sunshield has to be mounted in a way that no "bright" area of the inside front
of the camera is to be seen.
3.3 VCHD-2622 and VCHD-4322IR
Open the housing as previously described. On the camera board, there is a mini-joystick.
Press onto this joystick and a menu pops up in the video picture. You can now move the
joystick left/right/up/down in order to get to the desired menu item. To confirm your choice,
press onto the joystick
_________________________________________________________________________________
- 32 -
Werbung
Inhaltsverzeichnis
