U.S. Robotics MAXg USR5461 Installationsanleitung Seite 14

I accidentally clicked Cancel during the software installation procedure for the
Wireless MAXg USB Adapter.
Possible Solution:
Remove and reinsert the Installation CD-ROM into your CD-ROM drive. Follow the instructions in
this guide for installing the software.
The U.S Robotics interface did not begin when I inserted the Installation CD-ROM.
Possible Solution:
Some programs may disable the autorun feature of Windows. Close any open applications and
reinsert the Installation CD-ROM. If the Installation CD-ROM interface does not run automatically,
click Windows Start and then click Run. In the "Run" dialog box, type D:\setup.exe. If your CD-
ROM drive uses a different letter, type that letter in place of "D."
I inserted the Wireless MAXg USB Adapter before the Installation CD-ROM.
Possible Solution:
If you inserted the Wireless MAXg USB Adapter before the Installation CD-ROM, cancel the
installation procedure that is currently running. Insert the Installation CD-ROM, select your
language, click Installation, and then follow the on-screen instructions.
For more troubleshooting information or for advanced wireless configuration options, refer to the
Wireless MAXG USB Adapter User Guide on the Installation CD-ROM or go to www.usr.com/
support
The Setup Wizard was unable to detect my Internet connection.
Possible Solution:
You will need to manually configure your Internet connection. There are two methods of
instructions you can follow to setup your Internet connection: If you are still in the Setup Wizard
or If you have already closed the Setup Wizard.
If you are still in the Setup Wizard:
Select your Internet connection type: either Cable, DSL Router, satellite, ISN, LAN, or other or
DSL modem (also known as PPPoE). Depending on your selection, you will need to enter some
information that was provided by your ISP. After entering all of your necessary information,
click Next. Continue to follow the on-screen instructions to complete the Setup Wizard. For
more information about the settings, refer to the Web User Interface section of the Wireless
MAXg Router User Guide on the Installation CD-ROM.
If you have already closed the Setup Wizard:
Launch a Web browser. In the location or address line of your Web browser, type
http://192.168.2.1 to access the Web User Interface. Click the Internet tab. Select your
Internet connection type: either Cable, DSL Router, satellite, ISN, LAN, or other or DSL
modem (also known as PPPoE). Depending on your selection, you will need to enter some
information that was provided by your ISP. When you are finished, click Save. You should now
be able to access the Internet. For more information about the settings, refer to the Web User
Interface section of the Wireless MAXg Router User Guide on the Installation CD-ROM.
10