Gaggenau AW 560-190 Bedienungsanleitung Und Montageanleitung Seite 22

Filters and maintenance
Grease filters:
Metal filters are used to trap the greasy
element of the vapours that develop
during cooking.
The filter mats are made from non-
combustible metal.
Caution:
As the filter becomes more and more
saturated with grease, not only does the
risk of it catching fire increase but the
efficiency of the extractor hood can also be
adversely affected.
Important:
By cleaning the metal grease filters at
appropriate intervals, the possibility of them
catching fire as a result of a build-up of heat
such as occurs when deep-fat frying or
roasting is taking place, is reduced.
Saturation indicator:
The grease filter saturation display F flashes
after an operating time of 30 hours to you
indicate to you that you should clean the
grease filter. The grease filters can of course
be cleaned at any time, even if the grease
filter saturation display has not started to
flash.
Cleaning the metal grease filters:
In normal operation (1 to 2 hours daily),
the metal grease filter must be cleaned
1 x a month.
The filters can be cleaned in a dish-
washer. It is however possible that they
will become slightly discoloured.
The filter must be placed loosely, and
NOT wedged, in the dishwasher.
Important:
Metal filters that are saturated with
grease should not be washed together
with other dishes etc.
When cleaning the filters by hand, soak
them in hot soapy water first of all.
Do not use aggressive, acidic or caustic
cleaners.
Then brush the filters clean, rinse them
thoroughly and leave the water to drain off.
22
F
Removing and inserting the metal grease
filters:
Warning: The halogen bulbs must be
switched off and cool.
Before changing the grease filters,
ensure that the filter drawer has been
pushed in.
1. Press the catches on the front grease
filters and fold down the grease filters.
2. Press the catches on the rear grease
filters and fold down the grease filters.
3. Clean the grease filter.
4. Insert the clean filters back into the
hood.
5. Cancel the F in the display.
Press the button F.